Show/Hide Toolbars

MESYS Calculation Software

 

all_img116

On the pages “Graphics1” and “Graphics2” the results can be shown as graphics. If the parameter list was generated by “Generate list” and no more than two input parameters are used, lines are used for the diagram (for more than two input parameters or other sources just points are shown). The graphic area consists of two different y-axis, thus being possible to compare different types of output results (units) at a time. As shown in the picture at the top right, we can see that the axial clearance that optimizes the life varies depending on the moment load, but also which axial clearance brings down the contact pressure, pmax, to a minimum value.

Moreover, the line charts of the chosen outputs can be overlapped so that the user can easily perform any comparisons. This is shown in the picture on the bottom right: Although the basic life (L10h) is being primarily analyzed in the graphic, by doing a click on any of the all_img3-buttons, it could also be possible to add any other analyzed outputs with the same units of one of the two available y-axis.